Q. I've been looking at Planar and ViewSonic. Each of them has a model I like, but I don't want to overlook something else really good. There are so many choices out there and I've done enough searching and reading reviews to know I'd like some opinions about my specific needs.
I need height adjustable. I think I should be able to get 8ms response, 800:1 contrast and 600+ (?) brightness in the monitor I buy without too much trouble.
My eyes tire easily and I need a larger screen to help with that. I do mostly office-type work. I expect to be doing a little more photo or video in the near future - not professional. I'm not a gamer, but I need really good graphics to help my eyes. I want LCD, also, to reduce my radiation exposure.
I'm also interested in any opinions about buy at a store, or buy online.
Thanks for the help.
I need height adjustable. I think I should be able to get 8ms response, 800:1 contrast and 600+ (?) brightness in the monitor I buy without too much trouble.
My eyes tire easily and I need a larger screen to help with that. I do mostly office-type work. I expect to be doing a little more photo or video in the near future - not professional. I'm not a gamer, but I need really good graphics to help my eyes. I want LCD, also, to reduce my radiation exposure.
I'm also interested in any opinions about buy at a store, or buy online.
Thanks for the help.
A. i dont really have a suggestion but i know a site that gives reviews, ratings and online store pricing comparisons just click the link below
http://flat-panels-lcd.monitors.computers.merchanthound.com/
http://flat-panels-lcd.monitors.computers.merchanthound.com/
Monitor immediately goes into power save mode when I boot up my PC. Any ideas?
Q. I have a Dell LCD monitor and PC. Whenever I turn my PC on, the words Dell flash across the screen and then it immediately goes into power save mode. The green light is still on the PC, but monitor is off. I tried hooking my monitor to my laptop and it worked just fine. But when I hook it back to my PC it does the same thing over and over again. Please help.
A. Hi, First of all try a cold boot. Turn the PC off, on the back of the tower, there is a switch, usually on the right side. Turn it off. If there is not switch, unplug the tower from the PC and from the power outlet Let it sit 10 minutes. This will clear most problems. If it does not take care of you problem then, it could be that it is not the monitor which is in "power save mode", but the computer itself.
When you cannot get a computer out of "power save mode" by any other means, typically the cause is that the button-cell-type battery of your computer, which is located on the motherboard, is empty.
Usually, this happens on a computer which is a few years old, since its batteries will have run out after such a long time. (The motherboard battery is used to store various settings when the computer power is off, such as date and time. When your computer detects this battery is empty, it goes into a low-power mode).
The solution is to replace the button-cell battery on the motherboard of your computer:
1. open the case of your computer;
2.visually locate the motherboard (the main electronic circuit board) of your computer;
3.visually scan the motherboard for a button-cell battery (it looks like a digital watch battery, but a bit larger);
4.remove this motherboard battery from your computer;
5.restart your computer: it should now power up normally (you may get some warning messages during the start-up sequence, but ignore them);
6. set the date and time of your computer using the "Date and Time" control panel;
7.you can now use your computer normally, but you will lose date and time settings when you disconnect the computer power cord, since there is no motherboard battery present to store them;
8. take the motherboard battery to an electronics store and get a replacement;
install the new battery in your computer;
9.restart your computer, and set the date and time again; the settings will now be saved using motherboard battery power.
Good luck!! JOSA
When you cannot get a computer out of "power save mode" by any other means, typically the cause is that the button-cell-type battery of your computer, which is located on the motherboard, is empty.
Usually, this happens on a computer which is a few years old, since its batteries will have run out after such a long time. (The motherboard battery is used to store various settings when the computer power is off, such as date and time. When your computer detects this battery is empty, it goes into a low-power mode).
The solution is to replace the button-cell battery on the motherboard of your computer:
1. open the case of your computer;
2.visually locate the motherboard (the main electronic circuit board) of your computer;
3.visually scan the motherboard for a button-cell battery (it looks like a digital watch battery, but a bit larger);
4.remove this motherboard battery from your computer;
5.restart your computer: it should now power up normally (you may get some warning messages during the start-up sequence, but ignore them);
6. set the date and time of your computer using the "Date and Time" control panel;
7.you can now use your computer normally, but you will lose date and time settings when you disconnect the computer power cord, since there is no motherboard battery present to store them;
8. take the motherboard battery to an electronics store and get a replacement;
install the new battery in your computer;
9.restart your computer, and set the date and time again; the settings will now be saved using motherboard battery power.
Good luck!! JOSA
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar